Diagnostic Guide

Is a Catch Basin Right for Your Home?

The order matters. Identify your symptoms, verify property fit, and explore tailored drainage alternatives.

Signs the system is needed⚠️ Warning Signs

Signs You Need It

  • A low spot in the yard that holds water
  • Water pooling at the end of a walkway or slope
  • Mud or silt washing across paving
  • Mud, leaves or mulch collecting at the same spot after every storm
  • A planter or lawn bed that stays flooded while the rest of the yard drains
  • Water running off a slope and stopping against a wall or fence
Where the system fits✔ Perfect Match

Where It Fits

  • Low points in lawns, planters and side yards
  • The bottom of slopes and terraces
  • Where several surface flows meet
  • Side yards where water from two directions meets
  • Terraced yards with a drop between levels
  • Areas where a pipe run to the street or a dry well is available
Alternatives

Where It Does Not Fit

Water that comes up from the soil (use a French drain) · Long straight edges like a garage door (use a channel drain)

💧 Groundwater Issue?

Roof and surface pipes do not lower a high water table. An in-ground gravel filter does.

Explore French Drains ➔
🌊 Water Across Paving?

Surface water crossing a driveway or patio is caught by a channel drain, not an in-ground filter.

Explore Channel Drains ➔

How we build it

The order matters. Each step sets up the next one.

  1. Find the true low pointWe level the area and place the basin where water actually collects.
  2. Set the box on a stable baseA compacted base keeps the basin from settling and tipping the grate.
  3. Connect a solid outletThe outlet pipe is set below the inlet, so the water leaves quickly.
  4. Set the grate flushThe grate sits a hair below the surrounding grade so water flows in, and its load class matches the traffic.
Three stages of a catch basin installation: laser survey of the yard low point, setting the basin box and solvent-welding Schedule 40 PVC, and flush grate installation with sod restoration

What goes wrong when it is done badly

No sediment sump
Sand and leaves go straight into the pipe and clog it.
Basin above the low point
Water goes around it instead of into it.
Light-duty grate in a drive
It cracks under a car. Load class must match use.
No route for the overflow
If the outlet is blocked or undersized, the basin fills and floods the same low spot. We size the outlet for the area it serves.
Basin set in soft soil
Soil that is not compacted settles, and the grate tilts away from the flow. A compacted base prevents this.

What it costs

Price depends on the number of basins, pipe length to the outlet and any paving to cut. The estimate lists each basin and run. The on-site inspection starts at $99 and is credited toward repair.

Questions about Catch basin

How often does a catch basin need cleaning?

Check it before the rainy season and after big storms. The sump holds sediment that you scoop out by hand.

Can one basin serve several areas?

Yes, if the grading directs those areas to it. We often use one basin as the collection point for a whole side yard.

Is a catch basin the same as a French drain?

No. A catch basin takes in water that is already on the surface. A French drain collects water that is in the soil. Many yards use both, with separate pipes.

Where does the water go after the basin?

It leaves through a solid pipe to a safe discharge point, such as a dry well, the street where allowed, or a storm drain connection. The route is chosen on site and depends on slope and local rules.

Do I need a permit for a catch basin?

Often not for a small yard system, but it depends on the city and where the water discharges. Check your own city's website, and we will confirm what applies to your project.

How much does a catch basin installation cost?

It depends on the number of basins, pipe length and any paving to cut. Every project is priced individually after an on-site visit. The on-site inspection and estimate is $99, credited toward the work if you hire PiersPro.

Which areas do you serve?

We install catch basins in Los Angeles County and Orange County, within about 40 miles of Whittier.

How do I maintain it?

Check the inlets and grates before the rainy season and after big storms, clear leaves and sediment, and watch for water that no longer drains away. If it backs up, call us.

What happens during heavy storms?

A basin and its outlet are sized for the area they serve. Extreme storms can exceed any yard system, so we also look at grading and overflow routes on site.

Transparent Pricing

Start with an on-site drainage inspection

Good drainage starts with knowing which way your water moves. On every visit we shoot levels across the lot with professional equipment and map the elevations of your site. We use those numbers to design the pipe, its fall and the outlet, then price the job line by line. Led by a California Licensed General B Contractor (Lic #1110475).

  • Level shots across the lot with professional leveling equipment
  • An elevation map of your site, built for our own design calculations
  • Itemized estimate based on measured fall, not guesswork
  • The full $99 is credited toward the work if you hire us

Licensed General Contractor #1110475 (Class B, C-10). Requirements vary by city. Check your city’s building department for local rules.

ANY ON-SITE VISIT
Professional Inspection & Estimate
$99
Full site inspection, level survey and an itemized estimate for your drainage project • credited in full toward the work when you hire us
Calculate by ZIP & Book